PowerLevel
Specifies the source power level in dBm at which to perform a source power calibration. This value may be different than the applied test port power in the active PNA setup.
There is no default value.
Calibrations of the following type are required to set this value.
- CalAll Calibration
- Differential IQ (DIQ) Calibration
- Gain Compression Calibration
- SweptIMD Calibration
- IM Spectrum Calibration
- Noise Fixture (NFX) Calibration
- S Parameter with Power Calibration
- Spectrum Analyzer Calibration
This key corresponds with the following PNA SCPI commands:
SENSe<ch>:CORRection:GCSetup:POWer <num> parameter as explained the Keysight Documentation
SENSe<cnum>:CORRection:IMD:POWer <num> parameter as explained the Keysight Documentation
SENSe<ch>:CORRection:COLLect:GUIDed:PSENsor<pnum>:POWer:LEVel <value> parameter as explained the Keysight Documentation
Due to the limitations of the PNA be aware that this value is not applied when doing a source Power calibration. It is only utilized by the calibrations listed above. For source Power calibrations please see the key PowerLevelOffset
An Example:
TBD
Should include ThruDelay1to2